Windows NT Configuration for ECPI

The following section assumes that you have a correct and stable installation of Windows NT 4.0   Open My Computer. Open Control Panel. Open Network. Under the Protocols tab, make sure TCP/IP is installed. If it is not, see the Windows NT help files for installation instructions. Highlight TCP/IP and select Properties. Under the DNS tab, in the text box labeled Host Name, type your username. In the text box labeled Domain, type ecpi.com. Under DNS Server Search Order click the Add button and enter 216.141.24.3 (Primary DNS Server). Under DNS Server Search Order click the Add button again and enter 216.141.24.2 (Secondary DNS Server). Under the WINS tab, select Disable WINS. Click OK and restart your computer. After restarting, from My Computer, open Dial Up Networking. Enter ECPI in the text box labeled Phonebook Entry to Dial. Click More, then click Edit Entry and Modem Properties. Under the Basic tab, in the text box labeled Phone Number, type in 646-3274 for modems 48.8 and less. 647-4736 for 56k modems only. Under the Server tab, in the list box labeled Dial Up Server Type, select PPP. Under Network Protocols, make certain that TCP/IP is selected. Select Enable Software Compression and Enable PPP LCP Extensions. Click the button labeled TCP/IP Settings. Select Server Assigned IP Address. Select Specify Name Server Addresses. For Primary DNS enter 216.141.24.3 For Secondary DNS enter 216.141.24.2 Select Use IP Header Compression and Use Default Gateway on Remote Network. Click OK. Under the Script tab, select None. Under the Security tab, select Accept any Authentication including Clear Text. Click OK. To Connect to ECPI, Open Dial Up Networking and click Dial. A screen labeled Connect to ECPI will appear. Type your username, password.  Leave the space for Domain blank. Click OK or Connect.